Welcome to the Homepage of INTES GmbH, Stuttgart

If this webpage is presented to you in a simple layout, you are probably using an old browser (e.g. Netscape 4.78) without sufficient CSS-support. In order to be able to utilize this website in full extent, please use a modern browser.

Startseite
 

Static analysis with PERMAS

wire_set1
Stresses in a wire set and bellow during a
70 degrees opening of a car door.
wire_set2
Motion of wire set and bellow during a
70 degrees opening of a car door.
Cardan Shaft

PERMAS offers the following modules for static Analysis:

PERMAS-LS - Linear Statics
This module allows for linear elastic calculations based upon the assumptions of small displacements, small strains, and linear material behaviour.
PERMAS-CA - Contact analysis
Static analyses under nonlinear contact constraints
PERMAS CAX - Extended Contact Analysis
New contact solution algorithms for large contact models.
PERMAS CAU - Contact Geometry Update
Contact with large relative motions between contact partners.
PERMAS WLDS - Weldspot Model
Good representation of the global stiffness for spot welded structures.
PERMAS NLS - Nonlinear Statics
Nonlinear analysis of models with large displacements and/or nonlinear material behavior.
PERMAS NLSMAT - Extended Material Laws
Material laws for cast-iron and nonlinear material hardening under cyclic loads.
PERMAS BA - Linear Buckling
A linear buckling model to determine load factors and mode shapes.
PERMAS LA - Laminate Analysis
Modeling and analysis of multi-layered fibre-reinforced composites.
screw up
Screwing of a nut against a spring washer.
contact pressure
Contact pressure during screwing process.